After doing this for nearly 20 years I have decided to give back to the airgun community for all the support I have had over the years. We will be posting items here on this page that will be given away either on a monthly or bi-monthly basis depending on the product. Items will be posted and drawing date will be set. Please read all of the rules below to enter.
Thank you for the support!
This is our first item for this program. It is an ambidextrous Crosman 2240 Laminate Pistol Stock.
I have built rifle and pistol stocks in many configurations for these guns over the years but this particular design is new. Cut from green/gray laminate and fully fitted. It is inletted for a barrel band as you can see in the photos. My one piece rifle and pistol stock designs for the Crosman and Benjamin grip frame trigger unit guns are all cut from a single piece of wood (not cut in halves and glued together). I was the first in the industry to do this and as far as I know still the only one that does. This technique makes for a much more "conforming to the action" design both pleasing to the eye and feel when held and used.
Entering is easy-just subscribe to our website using the subscribe box in the header above-that's it!
The drawing will be held on April, 15 2021-yep tax day. Somebody will have some good news on that day no matter what!
We will contact you via the e-mail you subscribed with and you have 5 days to respond. If no response in that 5 days we will draw another winner. The item will be mailed to the winner via USPS Priority Mail to a Continental U.S. Postal Address ONLY. No international shipments. If you live outside the U.S. you can enter to win but the item will still only be sent to a U.S. address and you will be responsible for getting it from there.
ACTION SHOWN IN PHOTOS NOT INCLUDED!
Any questions or comments you can call or e-mail us and appreciate the interest-Good Luck!
940 727 3003
Design incorporates a trigger finger support and flared out palm support. Your middle finger also rests on wood with a larger surface area to support the weight of the gun instead of resting on the narrow metal trigger guard.
Factory grip screws are all that is needed to hold the action in the pistol stock. Action fits quite nicely holding the rest in place.
Action not included.
Installation is simple. Just slide the action straight down into the pistol stock. Make sure the safety is in a "neutral" position like seen in the photo above to install or remove the action. Failure to do so can result in damage to the pistol stock! Once the action is fully seated install the grip screws! Ready to use and enoy!